Led winkers resistor Highsider can-bus

Our newly developed Highsider resistor CBW1 fits most vehicles that have a can-bus system: the CBW1 resistor provides a required electrical load for your vehicle, which, if the dip switches are set correctly, will result in no flashing of the accessory flashers in the cockpit. In addition, a reliability is given: this means that if the accessory indicators fail due to an electronic fault, an error message is immediately displayed in the cockpit. Up to 2 channels can be operated, such as turn signals at the rear left and turn signals at the rear right: the Highsider CBW1 resistor can also be used on vehicles with original led turn signal equipment. Complete with detailed instructions with explained connection.

Features:

• Resistance values: 150, 170, 240, 300, 400, 600 and 1200Ohms
• Dimensions: height 11mm, body width 31mm, total width with tabs 46mm, length 40mm
• Cables length: 20cm
• Connections: yellow for input channel 1 (+), orange for output channel 1 (+), blue for input channel 2 (+), red for output channel 2 (+), grey for input mass (-) and black for output ground (-)